-------------------------------------------
 SessionsTools -> Run Batch Process runs
 through each SessionTools panel that is
 currently configured and presses the action
 buttons at the top right to re-perform the
 actions of the panel.
-------------------------------------------
Once an initial analysis of the data has been
performed, it is often necessary to re-run parts
of the analysis.  The Run Batch Process panel
automates this.

On the first pass through the analysis, each
panel is manually configured and action buttons
are pressed to generate data files.

The Batch Process panel is used to redo all or
parts of the analysis.

Examples

1) If motion correction is redone (e.g., using
   a different TR), all actions on all the
   subsequent panels need to be redone.  In this
   case, select all the boxes in the BATCH
   PROCESS panel.

2) If the FUNCT=>STRUCT registration is touched
   up, select Paint Surface, Calculate Surface
   Stats and Run Rendering Panels.

3) To use a different delay in the Fourier panel
   (affect F-stats), select Fourier and all
   following boxes

The Batch Process panel actually opens the
individual panels and presses the button, so you
can see the individual steps that are performed.
To skip a directory, Unset it (the previously
saved configuration will be retrieved if you
re-declare the directory).

The Batch Process Panel Saves Bitmaps

The one difference between running actions using
Batch Process and actually clicking the buttons
is that on the View Functional Data panel, the
bitmaps you have configured (Views: radio buttons
near the bottom of the panel) will actually be
saved into the <session>/image/rgb directory.

Run Each Panel Manually the First Time

It is currently not possible to run Batch process
initially because some files and directories
needed for configuring subsequent actions won't
yet exist the first time through the analysis.

